SEAL Image 410 Guía para resolver problemas descargar pdf (Pagina 25)

APPLYING AN OVERLAMINATE

This process involves applying an over laminate to an

image with the use of a sled or pre-coated substrate.

PREPARATION:

• Set your nip in accordance with the thickness of the

pre-coated board you will be using.

• Load a roll of pressure sensitive laminating film on

the top unwind shaft.

• Do not remove the release liner from the sled.

MEDIA: INK JET, ELECTROSTATIC, AND

PHOTOGRAPHIC

FILMS:

-- -- -- Top Unwind: Pressure-sensitive Laminate

____ Bott. Unwind: NA

LAMINATOR SETTINGS

CONTROL PANEL

Top Roller Temp: Off

Bottom Roller Temp: Off

Motor Speed Setting: 3-5 FPM (1-1.5 MPM)

WEBBING SETTINGS

Web Tension Top: Light

Web Tension Bottom: NA

Nip Setting: Substrate Determined

WEBBING PROCEDURE

• Pull the film down from the top unwind. Separate

the film from the release liner and lay the film over

the top roller.

• Connect the release liner to the windup tube with a

piece of tape. Attaching the release liner to a

cardboard core (over the windup tube) will allow

for easier cleanup.

• Pull the film evenly across the face of the main

rollers.

• Feed a leader board that is the same thickness as the

sled, into the nip. Make sure that the film is

adhered to the release liner on the leader board.

• Place an image face up on a sled and send it through

the nip.

• When the sled comes through, place another leader

board between the nips to hold the film.

• You may now cut the image away from the sled.

Sled

Pressure Sensitive Film

Media

Release Liner

Figure 18. Applying an Over-laminate Diagram

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Comentarios a estos manuales

Sin comentarios

SEAL Image 410 Guía para resolver problemas Pagina 25

Comentarios a estos manuales

Relacionado con productos y manuales para Laminadores SEAL Image 410