SEAL PRO 44 Guía para resolver problemas

ProSEAL® 25 & ProSEAL® 44 Laminators ProSEAL® 25 & ProSEAL® 44 Laminators Owner’s Operation Manual

10MOUNTING USING A ProSEAL® MOUNTING BOARD USING A ProSEAL MOUNTING BOARD • Refer to the instruction sheet packed with each box of ProSEAL Mountin

11MOUNTING USING A ProSEAL® POUCH BOARD • Refer to the instruction sheet packed with each box of ProSEAL Pouch Boards for specific instructions on

12ENCAPSULATING USING A ProSEAL® FLEXIBLE POUCH WITH A ProSEAL® SLED 1. Refer to the instruction sheet packed with each box of ProSEAL Flexible Po

13CLEANING YOUR LAMINATOR CLEANING THE LAMINATOR CAUTION! Disconnect the laminator from the power supply before cleaning. • The laminator may be

14TROUBLESHOOTING GUIDE Problem Cause Solution The power LED does not come on, when the nip setting knob has been set to one of the nip set

15SPARE PARTS PART DESCRIPTION SPARE PART CODE SPARE PART CODE ProSEAL 25 ProSEAL 44 Top Cover SP 144-165 SP 144-164 Right-Hand Inter

16GLOSSARY OF TERMS Cleaning Board: Boards specifically designed to attract and capture any adhesive that may be clinging to the rollers. Cold Mod

17PROCESS APPLICATION NOTES ________________________________________ ________________________________________ _____________________________________

18TECHNICAL SPECIFICATIONS Mechanical Height 12” (305 mm) 12” (305 mm) Overall Width 40” (1016 mm) 58” (1473 mm) Depth 15” (380 mm)

19LIMITED WARRANTY SEAL® Graphics warrants to the original consumer purchaser that each new SEAL® Image® Laminator, which proves defective in mater

2TABLE OF CONT ENTS TABLE OF CONT ENTS...

20ProSEAL® CONTACT INFORMATION SEAL BRANDS TECHNICAL SERVICE SEAL BRANDS TECHNICAL SERVICE – EUROPE AND ASIA PACIFIC (For technical as

3INTRODUCTION Thank you for purchasing a ProSEAL® Laminator. We have designed the ProSEAL Laminator to give you years of reliable service. As you

4IMPORTANT SAFEGUARDS When using electrical appliances, basic precautions should always be taken to reduce the risk of electrical shock and injury

5INSTALLATION The ProSEAL 25 and ProSEAL 44 are professional laminators designed for ease of use. The process speed and temperature have been pr

6UNPACKING, SET-UP AND INSTALLATION 1. Open the box, and lift the machine out (at least two persons necessary!). Grasp the machine 8”-10” (200mm-

7CONTROL KNOB The Control Knob (see Figure 1) is located on the right hand side of the laminator and is operated from the front of the machine. T

8CONTROL PANEL The Control Panel (see Figure 2) is located on the front right of the machine and has three LED indicators. A diagram of the Contr

9CONTROL PANEL DIAGRAM LED INDICATOR DESIGN The LED indicators are designed to indicate the on/off status of power, heat, and roller direction. Ple