SEAL PRO 44 Guía para resolver problemas descargar pdf (Pagina 8)

CONTROL PANEL

The Control Panel (see Figure 2) is located on the

front right of the machine and has three LED

indicators. A diagram of the Control Panel is

shown in Figure 3, on the next page.

• The top LED when lit indicates the machine is

plugged in and the power is on.

• The middle LED indicates if the heat is on. Heat is

required for ProSEAL



Pouch Boards and

ProSEAL



Flexible Pouches. If lit, the laminator is

in Hot Operation Mode and will heat up to its

factory setting. If not lit, the laminator is in Cold

Operation Mode.

• The bottom LED is the Temperature Ready

Indicator. If flashing slowly this indicates the

laminator is heating up and has not yet reached

process temperature. A steady light indicates the

unit has reached process temperature and is ready

for use. A rapid blinking light indicates that the

machine is too hot. This occurs when changing

from Hot Mode to Cold Mode. In this case, a

steady light indicates the machine has cooled

sufficiently for cold processes.

Figure 2. Control Panel

PUSH BUTTONS:

Below the LED indicators are two Push Buttons.

• The top button controls the heating of the roller; it

switches the heater on or off. Pushing this button

toggles the machine from Hot to Cold or Cold to

Hot Operation. The bottom LED, when constantly

on, will indicate the appropriate temperature has

been reached.

• Pressing the lower button reverses the direction of

the motor. The motor will continue to run in

reverse until the button is released. This is used to

clear jams or foreign objects, should one be drawn

into the laminator. In Case of Emergency: Either

Shut Off the laminator or use the Reverse Feature.

In Case of Emergency: Either Shut Off the

laminator or use the Reverse Feature.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comentarios a estos manuales

Sin comentarios

SEAL PRO 44 Guía para resolver problemas Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Laminadores SEAL PRO 44