SEAL PRO 44 Guía para resolver problemas descargar pdf (Pagina 10)

MOUNTING USING A ProSEAL

MOUNTING BOARD

USING A ProSEAL MOUNTING BOARD

• Refer to the instruction sheet packed with each box

of ProSEAL Mounting Boards for specific

instructions on mounting with a ProSEAL Board.

• Also, refer to the instruction sheet for information

on Compatible Media, Process Conditions and

Technical Information.

• Place the image to be mounted on the adhesive-

coated side of the mounting board (dull side of the

board).

• Cover your print with the “cover sheet” as marked;

(included with each box of ProSEAL Mounting

Boards); please be sure that the board is completely

covered by this sheet.

• Set the Nip-knob to the correct setting that matches

the Mounting Board thickness.

• Insert the board into the inlet opening. Ensure the

board will enter centered and straight. A gentle push

may be required to start the board into the

laminator.

• Hold the edges of the board until it is engaged in

the unit and the laminator begins pulling it on its

own.

• The board will feed through the laminator and

automatically exit at the rear of the unit.

CAUTION! The board will be hot! Allow it to

lie flat while cooling.

CAUTION! USE ONLY WITH ProSEAL



MOUNTING BOARDS 1/4” (6mm) THICK

OR LESS. DO NOT USE PLYWOOD,

METAL, CARDBOARD, SHARP OR HARD

BOARD WITH RAGGED EDGES OR ANY

TYPE OF PLASTIC.

MAKE SURE THAT ALL MEDIA FED INTO

THE LAMINATOR IS FREE OF STAPLES,

PAPER CLIPS, OR OTHER HARD

OBJECTS.

• Foam board may be cut or trimmed using a sharp

hobby knife such as an X-Acto Knife.

• Lightly score the paper first. Several passes of the

knife may be required.

• NOTE: Ragged cuts or pulling of the foam board

indicates a dull blade.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comentarios a estos manuales

Sin comentarios

SEAL PRO 44 Guía para resolver problemas Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Laminadores SEAL PRO 44