SEAL PRO 44 Guía para resolver problemas descargar pdf (Pagina 13)

CLEANING YOUR LAMINATOR

CLEANING THE LAMINATOR

CAUTION! Disconnect the laminator from the

power supply before cleaning.

• The laminator may be cleaned with a lint-free cloth,

lightly dampened with a mild soap and water

solution. Do not use spray-on cleaners. Do not

immerse any part of the laminator in water or other

liquids.

• Do not use an abrasive cleaner, which can damage

the painted surfaces.

• Do not allow water or liquids to enter the electrical

circuits, which may cause personal injury and/or

damage the equipment when power is applied.

CLEANING THE ROLLERS WITH ProSEAL



CLEANING BOARDS:

• The laminating rollers of your ProSEAL



laminator

should be periodically cleaned of adhesive build up

that might occur during normal operation.

IMPORTANT! Clean the laminating rollers to

prevent adhesive build-up and to ensure quality

output. Adhesive build up may eventually

damage the rollers.

• When laminating, a small amount of adhesive will

squeeze out between the laminate films and onto

the top and bottom rollers. This residue

accumulates through normal use and can be easily

cleaned off the rollers.

• ProSEAL



Cleaning Boards are specially

designed to attract and capture any adhesive that

may be clinging to the rollers. They are made from

materials that will not damage or cause excessive

wear to the ProSEAL Laminator.

• Turn on the unit and set for Hot Temperature

Operation. Once the machine has reached process

temperature set the Control Knob to 3/16” (5mm).

• Slowly insert the Cleaning Board into the inlet

opening. Ensure that the board enters centered and

straight. A gentle push may be required to start the

board into the machine. Hold the edges of the

board until it is engaged in the unit and the

laminator begins pulling it on its own.

• The board will feed through the laminator and

automatically exit at the rear of the unit.

CAUTION! THE BOARD WILL BE HOT!

Allow the board to lie flat while cooling.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

SEAL PRO 44 Guía para resolver problemas Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Laminadores SEAL PRO 44