SEAL PRO 44 Guía para resolver problemas descargar pdf (Pagina 4)

IMPORTANT SAFEGUARDS

When using electrical appliances, basic

precautions should always be taken to reduce

the risk of electrical shock and injury to

persons, including the following:

1. Read all instructions before connecting or operating

this unit.

2. Retain this Owners Manual for future reference.

For technical assistance beyond what is covered in

this manual contact Technical Service (details on

rear cover).

3. Save your carton! ProSEAL



laminators are

shipped in special cartons that protect them from

damage. Please store your carton in case your

ProSEAL

Laminator should ever require service or

need to be transported.

NOTICE! Failure to return machines properly

packed in original packaging will impose a

fifteen percent restocking fee plus costs to

repair shipping damage. Contact Technical

Service for Return Authorization (see rear

cover).

4. Do not use the laminator for other than its intended

use.

5. The laminator case may be cleaned with a lint-free

cloth, lightly dampened with a mild soap and water

solution. Do not use spray-on cleaners.

NOTE: Disconnect the laminator from the

mains supply before cleaning!

6. Do not immerse any part of the laminator in water

or other liquids.

7. This unit should be situated away from heat sources

such as heat registers or stoves/ovens.

8. The laminators’ location or position should not

interfere with its proper ventilation. Do not install

or place in a built-in enclosure such as a bookcase.

9. Do not operate the laminator with a damaged cord

or plug, or after the laminator has been dropped or

damaged in any manner. If purchased in

U.S./Canada, return the laminator to SEAL

Graphics or if purchased in Europe or Asia, return

to your ProSEAL

reseller for examination, repair,

or adjustment.

10. Do not let the cord hang over the edge of a

counter/bench or touch hot surfaces.

11. Always unplug the laminator when it is not to be in

use for a long period.

12. This unit should only be connected to a power

supply outlet of the voltage, amperage, and

frequency marked on the rear panel. The laminator

has a grounded plug (three prongs). To reduce the

risk of electrical shock, this plug is intended to fit

only a grounded outlet of the proper amperage, and

in only one way. If it does not fit in the outlet,

contact a qualified electrician.

WARNING! Do not modify the plug in anyway.

Save these instructions.

1 2 3 4 5 6 7 8 9 ... 19 20

Comentarios a estos manuales

Sin comentarios

SEAL PRO 44 Guía para resolver problemas Pagina 4

Comentarios a estos manuales

Relacionado con productos y manuales para Laminadores SEAL PRO 44