SEAL PRO 44 Guía para resolver problemas descargar pdf (Pagina 12)

ENCAPSULATING USING A ProSEAL

FLEXIBLE POUCH WITH A ProSEAL

SLED

1. Refer to the instruction sheet packed with each box

of ProSEAL Flexible Pouches for specific

instructions on encapsulating.

2. Also, refer to the instruction sheet for information

on Compatible Media, Process Conditions and

Technical Information.

3. The ProSEAL Flexible Pouch consists of two

pieces of film that are hinged at one end, along a

short side. Separate the two pieces starting at the

end opposite the hinge. Take care not to break the

hinged seal.

4. Insert the article to be laminated in the pouch so

there is at least a 1/8” (3.5mm) border around each

of the sides. This ensures that moisture never

reaches the image.

5. Place the pouch with the image on the sled included

with the Flexible Pouches or ProSEAL Sled. (The

ProSEAL Sled is a sled to assist in the handling of

large Flexible Pouches. It is made of materials that

will not damage or cause excessive wear to your

ProSEAL Laminator.)

6. Smooth out any wrinkles with the side of the hand

or a soft flexible squeegee.

7. Tape the leading edge of the pouch to the sled using

masking tape.

8. Adjust the Control Knob to the 3/16” (5mm)

setting for the ProSEAL Sled.

9. Be sure that the heat is on (the middle LED is ON

and the bottom LED is constantly ON.

10. Slowly insert the sled with the Flexible Pouch on

top into the inlet opening.

11. Ensure that the sled is centered and straight. A

gentle push may be required to start the sled into

the laminator.

12. Hold the edge of the sled until it is engaged and the

laminator begins pulling it on its own.

13. The sled will feed through the laminator and

automatically exit at the rear of the laminator.

CAUTION! The sled will be hot! Allow it to lie

flat and cool before removing the tape.

14. If there is any dirt or adhesive on the surface of the

Flexible Pouch, it can be removed by dampening a

lint free cloth with ISO Propyl Alcohol (IPA) and

wiping the surface.

CAUTION! Always use care when using

Isopropyl Alcohol (IPA)! IPA is very flammable.

The flash point of IPA is 11°C (51.8°F). The

self-ignition temperature is 400°C (752°F).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

SEAL PRO 44 Guía para resolver problemas Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Laminadores SEAL PRO 44