SEAL PRO 44 Guía para resolver problemas descargar pdf (Pagina 7)

CONTROL KNOB

The Control Knob (see Figure 1) is located on the

right hand side of the laminator and is operated from

the front of the machine.

The Control Knob has four (4) purposes.

1. Turn the power on.

2. Turn the heat on.

3. Turn the rollers on.

4. Adjust the height of the rollers.

To Operate the Control Knob:

• Grasp it with your right hand and push in

approximately 1/4” (6mm) to the left.

• Once the knob has disengaged from the stop, it may

be rotated forward or backward (clockwise or counter-

clockwise, as viewed from the right hand side of the

unit).

Figure 1. Control Knob

To Switch the Power ON:

• Push the knob in and rotate it slowly towards you

(counter clockwise as viewed from the right side

of the unit).

• The top LED indicator will light up to indicate

that the power is on.

To Set the Height of the Rollers:

• Continue to rotate the knob until the desired

measurement corresponds with the indicator

window at the base of the knob.

• Select the measurement that indicates the

thickness of the material you will be using with

the machine.

• Releasing the knob so that it moves back to the

right and clicks into place will set the rollers for

use.

• The measurements on the knob, 1/4” (6mm),

3/16” (5mm), 1/8” (3mm) and 1/16” (1.5mm)

correspond to ‘Pouch board thickness’.

• There is also a fully closed stop, 0” (0mm) for

future film only applications.

To Turn the laminator OFF:

• Grasp the control knob and push to the left.

• Rotate the knob away from you as far as it will go

(clockwise).

• This will shut off the machine and open the

rollers to permit objects to be removed.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comentarios a estos manuales

Sin comentarios

SEAL PRO 44 Guía para resolver problemas Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Laminadores SEAL PRO 44