SEAL PRO 44 Guía para resolver problemas descargar pdf (Pagina 11)

MOUNTING USING A ProSEAL

POUCH BOARD

• Refer to the instruction sheet packed with each box

of ProSEAL Pouch Boards for specific instructions

on mounting/laminating with a ProSEAL Board.

• Also, refer to the instruction sheet for information

on Compatible Media, Process Conditions and

Technical Information.

• Carefully examine the board to determine which

edge is sealed. There is a 1/8” (3mm) tape edge on

the sealed end.

• Starting at one of the corners, opposite the sealed

edge, gently lift and peel back the film. Care should

be taken not to break the sealed hinge.

• Center the image to be laminated on the board and

lay the film back over it.

• Set the Control Knob to the correct setting that

matches the Pouch Board thickness.

• Ensure that the unit is set to Hot Mode and that the

middle LED is not flashing.

• Slowly insert the Pouch Board into the inlet

opening. Ensure that the Pouch Board will enter

centered and straight. A gentle push may be

required to start the board into the laminator.

• Hold the edges of the Pouch Board until it is

engaged and the laminator begins pulling it on its

own.

• The Pouch Board will feed through the laminator

and automatically exit at the rear of the unit.

CAUTION! The board will be hot! Allow it to

lie flat while cooling.

• If there is any dirt or adhesive on the surface of the

board, it can be removed by dampening a lint free

cloth with ISO Propyl Alcohol (IPA) and wiping

the surface.

CAUTION! Always use care when using

Isopropyl Alcohol (IPA)! IPA is very flammable.

The flash point of IPA is 11°C (51.8°F). The

self-ignition temperature is 400°C (752°F).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Sin comentarios

SEAL PRO 44 Guía para resolver problemas Pagina 11