SEAL PRO 44 Guía para resolver problemas descargar pdf (Pagina 6)

UNPACKING, SET-UP AND INSTALLATION

1. Open the box, and lift the machine out (at least two

persons necessary!). Grasp the machine 8”-10”

(200mm-250mm) from either side, at the bottom

aluminum extrusions. Be careful: the polyethylene

bag is slippery!

2. Place the machine on the work area described in the

previous page.

3. Remove the protective polystyrene foam end

covers.

4. Remove the polyethylene bag.

5. Remove the protective sheet, placed between the

rollers. To do this: push the knob, situated at the

right-hand side, fully inward, and rotate fully

clockwise.

6. Inspect the machine for any physical damage (if

damage does exist, report this to the Freight

Company or Dealer to file a claim). Contact

Technical Service (see rear cover) to determine if a

replacement machine should be shipped to you.

NOTICE! Retain original packaging. Failure to

return machines properly packed in original

packaging will impose a fifteen percent

restocking fee plus costs to repair shipping

damage. Contact Technical Service for Return

Authorization (see rear cover).

7. Plug the power cable into the grounded outlet with

appropriate service as described in the previous

page.

8. Push in and turn the Control Knob to the 3/16”

(5mm) setting (the motor and heater will turn on

automatically.) Refer to the Control Knob section.

9. Wait 10-15 minutes to determine if the unit has

achieved operating temperature (the bottom LED

indicator light will be on (it will flash while coming

up to temperature.)

10. When the bottom (heat) LED indicator is

constantly lit, you are ready to use your ProSEAL

laminator.

NOTE: Set the nip to a position other than fully

closed when not in use.

NOTE: The laminator may emit vapors the first

few times it is used. There is no need for

alarm. This is normal and will cease after

several minutes of use.

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Comentarios a estos manuales

Sin comentarios

SEAL PRO 44 Guía para resolver problemas Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Laminadores SEAL PRO 44