SEAL PRO 44 Guía para resolver problemas descargar pdf (Pagina 14)

TROUBLESHOOTING GUIDE

Problem Cause Solution

The power LED does not come on,

when the nip setting knob has been

set to one of the nip settings (board

thickness).

• The power cable has not been

plugged in the mains wall outlet.

• The (external) mains circuit

breaker is tripped.

• Check if the power cable is

plugged into the mains wall

outlet.

• Reset the mains circuit breaker.

Pouch Boards are not drawn in by

the machine, and the motor is

making a louder humming noise [it’s

stalling]. Only after pushing very

hard, the boards are accepted.

• The pouch board is too thick for

the chosen nip setting.

• Boards of another make are

used.

• Change the nip setting to the

next thickness.

• Use only ProSEAL



Pouch

Boards. Use of other boards will

void your warranty.

The quality of the lamination is poor:

silvery areas on dark surfaces are

visible, or the edges of the image are

not sealed well.

• The roller temperature is too

low.

• The roller pressure is too low.

• Contact your Technical Service

Representative.

• Change the nip setting to the

next thickness.

The quality of the lamination is poor:

especially laminated Inkjet prints

show bubbles.

• The roller temperature is too

high.

• Contact your Technical Service

Representative.

TECHNICAL SERVICE

If the machine does not reach temperature or you

do not get the results you desire, please contact

your Technical Service representative (see rear

cover).

When calling for Technical Service please have the

Laminator Serial Number (listed on the Identification

Plate) available. The Laminator Serial Number is

located on the rear side of the laminator.

SERVICING AND REPLACEMENT PARTS

Service and maintenance must be performed fully in

accordance with the instructions. Servicing by any

unauthorized technician voids the warranty. The

service technician must use replacement parts

specified by SEAL

Graphics.

NOTE: Service Technicians must perform safety

checks after completing any service or repairs to

the laminator.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

SEAL PRO 44 Guía para resolver problemas Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Laminadores SEAL PRO 44